poplalatino.blogg.se

1. DISTECH CONTROLS THERMOSTAT OVERRIDE INSTALL
2. DISTECH CONTROLS THERMOSTAT OVERRIDE MANUAL
3. DISTECH CONTROLS THERMOSTAT OVERRIDE UPGRADE
4. DISTECH CONTROLS THERMOSTAT OVERRIDE FREE

Temperature Input supports the following types of sensors:.All Universal Inputs have 12-bit or 16-bit resolution which supports the following types of inputs: ISMA-B-8U-IP provides 8 Universal Inputs (UI). One 10BASE-T/100BASE-TX Ethernet port BACnet/IP or Modbus TCP.ISMA-B-8I-IP provides 8 Digital Inputs (DI) for Dry contact inputs and Fast pulse counter up to 100 Hz that can be saved in EEPROM memory. UI = Voltage/Current/Resistive/Dry ContactĭI = Dry Contact/Fast pulse counter (100 Hz) Supported five types of communication: Modbus RTU, Modbus TCP, BACnet MS/TP, BACnet IP, USB.Save configuration file, load configuration file.Configure universal inputs for temp, analog, contact closure.Monitor digital inputs/pulse counter values.

DISTECH CONTROLS THERMOSTAT OVERRIDE UPGRADE

Upgrade firmware, reset module, reload module and load default settings.Connection by USB cable without powering the module.

DISTECH CONTROLS THERMOSTAT OVERRIDE INSTALL

There is no need to install any additional software or drivers to run iSMA Configurator. This software is intended for Windows operating system and can be run on Windows 7, 8 or 10. This simple and intuitive to use software is the convenient tool for every configurable I/O user. It allows monitoring the device's operating parameters, remote change of I/O module output states and input modes.

DISTECH CONTROLS THERMOSTAT OVERRIDE FREE

The free downloadable software provides communication with the use of USB, BACnet MS/TP, Modbus RTU, BACnet IP or Modbus TCP. The iSMA Configurator has been designed to perform configuration, firmware updates and diagnostics on the configurable I/O.

DISTECH CONTROLS THERMOSTAT OVERRIDE MANUAL

Manual output override switches on 4 and 8 point units.Ingress Protection Rating: IP40 – for indoor installation.LEDs for - inputs, outputs, power and communications status.10 VDC and 20 mA load allows control of relays or SSR with PWM All Digital Inputs work as retentive counters up to 100 Hz.Supported temperature sensors in Fahrenheit and Celsius degrees.Universal Inputs for temp, analog, resistance, binary with up to 16-bit resolution.BACnet/IP and Modbus TCP communication protocols in a single module dip switch selectable.All IP version modules are equipped with a built-in Modbus TCP/IP for RS485 gateway which allows for establishing a connection with RS485, additional I/O modules, or 3rd party devices. All modules use half-wave rectified low voltage power supply that allows for sharing of power with other 24 VAC/VDC devices. The modules are housed in a compact UL approved self-extinguishing plastic enclosure, rated for operation in -10☌ to +50☌ (14☏ to 122☏) environments and DIN rail or panel mounted typically in a control enclosure. A single module supports BACnet MS/TP or Modbus RTU/ASCII with a simple dip switch selection. Additional modules supply a mix of universal inputs and/or discrete with relay outputs and analog outputs. For applications not requiring universal inputs there are modules with discrete inputs that support contact closure and retentive pulse counting at 100Hz. The configurable I/O modules provide universal inputs that support temperature, analog, resistance and binary in a single module.